*** As part of the forum post crash revival, The phpBB software has also been upgraded from 3.2.1 to 3.2.7 ***
Please report any issues that you may experience and thanks again for your patience and understanding during the outage.

(You may clear this alert message by clicking the X in the top right corner of this box)
-Sigmaz (jon)

New owner in Connecticut.

Place to come in and say HI to the club after you have registered

Moderators: 2stroketurbo, Subie Gal

Post Reply
Author
Message
Gamestermike89
Posts: 12
Joined: 1 month ago

New owner in Connecticut.

#1 Post by Gamestermike89 » 1 month ago

Hello Subaru guys and gals. I'm a proud new owner of a 69 sedan. I've been looking for one of these cars for almost 10 years now. I finally found one in decent enough shape to start this endeavor. It's been sitting in a garage for almost as long as I've been looking for it. Call it destiny. Let me give you folks The rundown.
1). It has not run in over 10 years. Power coming from coil. But no spark. I would like to upgrade to electronic ignition I think this would solve the problem. Can someone tell me who to get in contact with buy one of these things.
2). The Vacuum assembly thing (forgive me I don't know what it's called) underneath the gas tank is missing. If this is a crucial part I need to purchase one from the community.
3). Right rear brake is seized all the rest just need to be used. can someone tell me who I can send the cylinders to get them upgraded / repaired.
4). The brake fluid reservoir is low what type of fluid should I use and should I flush it?
5). Should I go through some procedure to get this thing going again being that it has sat so long. Mainly is there some kind of startup sequence that I should be going through.

Thanks in advance to all those of you who can help.
Attachments
IMG_0949.jpg
IMG_0958.jpg
IMG_0958.jpg (40.11 KiB) Viewed 394 times
1969 Subaru 360 sedan
1982 Cadillac Fleetwood brougham.
1999 Toyota Camry (every day beater)

User avatar
kjrcace360fan
360 Master
Posts: 2833
Joined: 9 years ago
Location: Charleston, West Virginia

Re: New owner in Connecticut.

#2 Post by kjrcace360fan » 1 month ago

Get the book of reprints B O R

#1 Remove the oil pump.
#2 Either make sure the oil pump is functioning properly or use mixed gas to get it going from an exterior gas tank. I use a Briggs aux poly tank. I also would suggest 16 to 1 gas to oil ratio for the first start ups
#3 oil the rings through the spark plug holes with two stroke oil
#4 squirt some oil toward the con rod bearings through the intake holes in the cylinders
#5 turn it over several min on the starter without the plugs Put some rags on the top to catch the oil .
Then give it a shot.

make sure you points are opening
Spud the Orange Young, Hippie, Little John the Truck & Dune Buggy.

oldone
360 Master
Posts: 4277
Joined: 8 years ago
Location: Norman Okla / OU SOONERS Thunder

Re: New owner in Connecticut.

#3 Post by oldone » 1 month ago

I would think Dot 3? if it has sat that long' Does it have a solid /firm brake pedal ? I sell the wheel cylinder cups on Ebay. Chances are someone has sleeved them if it still has fluid & a pedal.
CK to see if the points aren't dirty or corroded & gaped correctly, check timing. Also ck to if plug wires aren't crossed # 1 cyl in on the distributor side.
Check the crankcase for excessive oil, while your'e lubing the rods, some times the oil pump check valve leaks oil into the crankcase from setting.
Kevin covered the most important think drop & cK the oil pump.

subaru360nut
Club Founder - 360 Guru
Posts: 3761
Joined: 14 years ago
Location: Tucson AZ (I'm Ed Parsil)

Re: New owner in Connecticut.

#4 Post by subaru360nut » 1 month ago

Welcome to The Club! We are here to help.
Check Roster for other members in CT & MA

Ed
300,000+ miles on Subaru 360s since Feb. 1975, and have never (yet) been stuck on the road with one!

Gamestermike89
Posts: 12
Joined: 1 month ago

Re: New owner in Connecticut.

#5 Post by Gamestermike89 » 1 month ago

Where do I find the roster. I'm interested in meeting others on my area?
And the points are totally fried. The condenser is prob shot. But I want to upgrade it none the less.
The breaks worked fine getting it off the trailer. Maybe they were already relined. How can I tell?
1969 Subaru 360 sedan
1982 Cadillac Fleetwood brougham.
1999 Toyota Camry (every day beater)

oldone
360 Master
Posts: 4277
Joined: 8 years ago
Location: Norman Okla / OU SOONERS Thunder

Re: New owner in Connecticut.

#6 Post by oldone » 1 month ago

Subaru 360's have some common brake problems, the master & wheel cylinders are aluminium & pit due to corrosion from water in them. The other problem is the brake linings that are bonded to aluminium shoes become unbonded due to corrosion also. The most common fix is to resleeve the M/C & wheel cylinders & have the brake shoes relined, while you are at it new rubber brake lines will help complete the job. :wink:

AnthonyC
360 Master
Posts: 619
Joined: 3 years ago
Location: long beach,california

Re: New owner in Connecticut.

#7 Post by AnthonyC » 1 month ago

Welcome to the club from Sunny Southern California
You will find alot of helpful folks on here
If you need parts I have some here in California that I make
But I also have A store in Japan that I can pull parts from that are not available here in the U.S.A.
I have the following items arriving in this month from Japan
Nippon Denso Distributor Parts

Distributor assembly
Caps
Rotors
Points
Condensers
Coils

As usual When I looked on the order all parts have been sold and I haven't received them in yet
So if you need some I can always order more

Let me know if I can Help
I have over 200 parts for them
To many to list

Thanks
AnthonyC
My Cell
562-236-6331
Email autotrixinc@gmail.com

Gamestermike89
Posts: 12
Joined: 1 month ago

Re: New owner in Connecticut.

#8 Post by Gamestermike89 » 1 month ago

Thank you AnthonyC. But I'm not looking to "fix" the points I want to trash them altogether. I was told by Mark (2stroketurbo) that someone in this community makes a electronic ignition upgrade package that I want to purchase. I will most likely be contacting you for other parts though. Thanks again!
1969 Subaru 360 sedan
1982 Cadillac Fleetwood brougham.
1999 Toyota Camry (every day beater)

User avatar
kjrcace360fan
360 Master
Posts: 2833
Joined: 9 years ago
Location: Charleston, West Virginia

Re: New owner in Connecticut.

#9 Post by kjrcace360fan » 1 month ago

Pertroics ? of something like that. Mark was envolved in getting them made but I don't know where to get them. I'll look to see if I can get the info.
Spud the Orange Young, Hippie, Little John the Truck & Dune Buggy.

User avatar
books1
360 Master
Posts: 4843
Joined: 9 years ago
Location: Perth, Western Australia ..... Young SS downunder

Re: New owner in Connecticut.

#10 Post by books1 » 1 month ago

Pertronix. Read all about it here

Gamestermike89
Posts: 12
Joined: 1 month ago

Re: New owner in Connecticut.

#11 Post by Gamestermike89 » 1 month ago

Thank you book1, I read the entire article and contacted Stevec this morning and purchased the kit. Can't wait for it to arrive.
1969 Subaru 360 sedan
1982 Cadillac Fleetwood brougham.
1999 Toyota Camry (every day beater)

User avatar
books1
360 Master
Posts: 4843
Joined: 9 years ago
Location: Perth, Western Australia ..... Young SS downunder

Re: New owner in Connecticut.

#12 Post by books1 » 1 month ago

COOL! :D

Gamestermike89
Posts: 12
Joined: 1 month ago

Re: New owner in Connecticut.

#13 Post by Gamestermike89 » 3 weeks ago

I'm sick of using a big adjustable on the castle nuts for the hubs. Does anyone know the size they are. I can't find it in the bor.
1969 Subaru 360 sedan
1982 Cadillac Fleetwood brougham.
1999 Toyota Camry (every day beater)

CT360
Posts: 15
Joined: 12 years ago

Re: New owner in Connecticut.

#14 Post by CT360 » 3 weeks ago

Hi Welcome to the Fun word of Subaru 360 land.
I live in Milford Ct and I have a few cars and a truck and tons of parts. ( one driver and tree project cars ) ( Truck needing lots of work ).
I have to say My driver car is all original even the tires. The only work i did was resleeve brake cylinders & New hoses and master just the rubber parts .
The engine. The rings were seized in pistons and cracked when trying to remove. Hone cylinders and new piston ring. All stock.
Even the spark plug are original ( I think ) The car has just over 11,000 miles and have to say it starts up every time with no problem with points and condenser.
This car was in a barn in weston Ct It was my friends dads and I mean buried in the barn. I remember it in 1977 when you could barely see it so much sh** was
around and on top of it. I got the car in 2007.
If I can be of any help let me know. What part of the state are you in.
Good luck Damian

Gamestermike89
Posts: 12
Joined: 1 month ago

Re: New owner in Connecticut.

#15 Post by Gamestermike89 » 1 week ago

Ok I have checked the oil pump for proper operation. I have mixed the first gallon of clean gas with oil 20:1. I have installed the pertronix EI. And I think I have it static timed close enough to fire. In the morning I will start her for the first time in 11 years. Wish me luck!
1969 Subaru 360 sedan
1982 Cadillac Fleetwood brougham.
1999 Toyota Camry (every day beater)

jcimino
360 Master
Posts: 370
Joined: 3 years ago
Location: Dushore, PA

Re: New owner in Connecticut.

#16 Post by jcimino » 1 week ago

SteveC has the Pertronix Electronic Igntion upgrade kits in stock, $108 shipped. send him a PM
Jim Cimino

Gamestermike89
Posts: 12
Joined: 1 month ago

Re: New owner in Connecticut.

#17 Post by Gamestermike89 » 5 days ago

jcimino yes I know I already purchased it from him and installed it. But I have another wiring problem apparently.
1969 Subaru 360 sedan
1982 Cadillac Fleetwood brougham.
1999 Toyota Camry (every day beater)

Post Reply

Who is online

Users browsing this forum: No registered users and 5 guests